** Please note the old style T3 / MT3 coils which was the base and coil together have been discontinued and will no longer be available. These are the new coils that are separate from the base. The coils will work with your old style T3 / MT3 clearomizers you just have to get the new base to upgrade your old style to the new "s" style. The "s" stands for Separate because the new versions have a separate base and coil. The reason for this upgrade was to reduce costs and waste by making the base reusable and now the only piece that needs replacing is the coil head.
Replacement T3s & MT3s Bottom Feeder Atomizer Coils are available in 1.8ohm, 2.2ohm and 2.5 ohm.
Replacement T3s & MT3s Atomizer Coils are available in 1.8ohm, 2.2 ohm, and 2.5ohm. If you're using a standard 3.7v eGo battery the 1.8ohm or 2.4ohm will work best, if you are using an eGo Variable Voltage Battery or a Higher Voltage Device the 2.8ohm is the best option for you.
This is a SINGLE coil
How to fill T3s / MT3s Bottom Feeding Clearomizer:
Unscrew the bottom assembly from the tube
Hold the T3s / MT3s tube upside down with the drip tip facing down
Fill with 3ml E-Juice by tilting the clearomizer at a slight angle and dripping juice down the inside wall against the outer wall of clearomizer.
Do not put eliquid into the center tube as it will leak out the bottom of clearomizer.
Screw the bottom assembly back onto tube.
- Screw onto electronic cigarette device and you're ready to vape.
How to change the atomizer head on T3s and MT3s Bottom Feeding Clearomizer:
Unscrew the bottom assembly from the tube
Remove the T3s / MT3s coil from the base and and simply screw a new coil into the base.
Screw base back onto T3s / MT3s Bottom Coil Clearomizer
Fill with 3ml E-Juice by tilting the clearomizer at a slight angle and dripping juice down the inside wall against the outer wall of clearomizer.
Do not put eliquid into the center tube as it will leak out the bottom of clearomizer.
Screw onto electronic cigarette device and you're ready to vape.