The Aspire Nautilus Mini is the next generation of tank systems.

The Nautilus Mini uses the Aspire “BVC” (Bottom Vertical Coil) atomizer technology, and is made of stainless steel and Pyrex glass,

This new technology is designed to last longer whilst still giving users the purest and cleanest taste from e-liquids.

The Nautilus Mini includes an improved four-port adjustable airflow system that is both user friendly and reliable.

This unique four-port system allows the user to adjust the draw, warmth of vapor, and amount of vapor produced.

The Nautilus Mini design also makes it easy to carry, install, and refill.

Aspire claims this clearomizer tank system offers better taste, more stability, longer lifetime, more vapor.

Drip Tip: has a stainless round drip tip with a silicon rubber sealing ring, you can use any favourite 510 drip tip with this device.

Top cap: Stainless steel polish knurling texture makes Nautilus have a nice appearance.

Tank: The Pyrex glass tank has a unique thread design. There is a very nice platinum silk printed logo and scale on the tank.

Base Connector: This Nautilus Mini has been improved to the upgraded version. You can control the airflow to your personal preference by rotating the valve 0-ring. Though the bottom flexible connector design allows it to match any 510 battery, this 1.8 ohm bottom vertical coil works best with variable volt batteries that produce at least 3.9 volts or 6 watts.

These are genuine Aspire products with a scratch off security authenticity code which you can verify by visiting their website.

You will receive:

1 x 2ml Nautilus Mini Tank (1.8 ohm BVC atomizer pre-installed)

1 x Replacement BVC atomizer (1.8 ohm)

1 x EGO threaded cone

1 x User manual

The Nautilus Mini is a bottom coiled tank, so when refilling your e-liquid or replacing your BVC head ensure to first turn the Nautilus Mini upside (especially when there is e-liquid in the tank!)

How to refill the Nautilus Mini:

1. Unscrew the base connector.

2. Add vapour juice against the inner wall of the tank. WARNING: DO NOT add e-liquid into the middle of the airflow hole.

3. After filling your tank up not above the MAX level indicator, carefully screw back on the base connector.

- After filling allow the juice to soak-in for several minutes before vaping.

- Avoid over-tightening the tip, the clearomizer parts, or the clearomizer connection to the battery.

- Avoid filling your tank above the Max level indicator.

How to replace the Nautilus Mini coil:

Unscrew the metal bottom base connector from the tank. If there is any e-liquid in your tank do not unscrew the top cap as it will all spill out

Unscrew the coil head from the base connector and replace with the new coil head.

Refill with e-liquid as required.

Screw the bottom base connector back on the tank.

Wait a few minutes for the e-liquid to soak into the coil before vaping again.

WARNING: Fully close but DO NOT over-tighten the base connector. Do not fully close the top cap, screw on and ideally leave half a twist before it fully closes. This is so that should the bottom base connector become tight and difficult to unscrew you can then fully screw down the top cap which will push the base connector out a little allowing it easier to unscrew off.

When you experience a decrease in vapour production or the quality of the flavour is diminishing this may be an indication your coil is due to expire so this coil should be replaced t o continue your vaping experience (on average 1 coil per 30ml's of liquid vaped)

We recommend setting your device to an output of 4 volts or 6 watts to start for this clearomizer, then gradually increase as preferred.