|
Genuine Vision "Mini" Vivi Nova 2ml (v2.5) clearomizer tank kit. With replaceable atomizer heads/coils and a 2ml tank, this tank is sure to please! Also referred to as v3 at some other sites. These have the improved transparent tank body, long wicks, and air holes in the bottom stem, just above the threads. Long wicks can be trimmed to desired size by the user, though this is not necessary for operation of the unit. *Price per kit.
Kit includes:
1 - 1.8ohm coil
1 - 2.4ohm coil
1 - 2.8ohm coil
1 - clear 2ml tank with top & bottom caps
1 - drip tip
How to fill the Vivi Nova
1. Unscrew the top cap off the Vivi Nova tube and the tip should come off along with it. Note: Try not to remove tip out of cap as much as possible. If you do, the “O”-ring that surrounds the base of tip could get broken or worn from constant removal.
2. Notice the heating coil in the center of the tube, there is an airhole in the middle, avoid getting ejuice in this airhole. Fill with your favorite e-juice or simply tilt the Vivi Nova at a 45 degree angle and drip down the sides of the tubing avoiding the center hole filling no more than the bottom edge of the white plastic cap on coil head. Overfilling will result in flooding. Note: If you accidentally get juice down airway, replace cap and blow through tip out the bottom with a tissue underneath.
3. Screw back on the top cap tight. Allow the new wicks to saturate for at least 5 minutes on a new wick or,
4. Attach to battery and prime by drawing at least 10 times without pressing battery button.
How to change the coil atomizer or the wick
1. Unscrew the bottom end cap and pull out the coil base and coil head attached.
2. Gently unscrew the coil head from the top of the coil base.
3. Screw the new head back into the coil base tightly so no ejuice leaks into the tube and you have secure connection for conductivity with the battery.
4. Screw bottom cap back up into the tank and screw back on tightly.
How to clean the Vivi Nova
1. If you are able to change the coil heads and fill the Vivi Nova you already have all the skills to clean one.
2. Screw off the top cap and dump out any excess ejuice
3. Screw off the bottom end cap and pull out of tube, unscrew the used heating coil.
4. Now you have all the pieces apart so rinse them with hot (not burning hot) water Or, you can allow all the pieces to steep in hot water, either way, it won’t hurt anything.
Finally, how to clean the heating coil so it can be reused.
1. Rinse with hot water.
2. Use a paper towel or clean cloth to dry off the wicks, then let dry. If you are in a hurry, you can put the heating coil back into you Vivi Nova keeping the top off and attach to a battery. Then do quick “dry burn” blasts by hitting the battery at low voltage for 2 seconds at a time until you think it’s dry enough to refill with ejuice.
|
|
|